SAMPLE QUESTONS :
Question: 1
When a write from a SAN host is received, the information is stored within the controller before it is written to the underlying RAID. In this scenario, which component stores the data?
A. HBA
B. FlashCache
C. Flash Pool
D. NVRAM
Answer: D
Question: 2
An administrator notices that the applications are running slowly. The administrator wants to determine which component on the ONTAP subsystem is experiencing the most latency.In this scenario, which command would you use to accomplish this task?
A. Run -node * stats show system::sys_avg_latency
B. Statistics system show
C. Run -node * -command sysstat -x 1
D. Gos statistics latency show
Answer: D
Question: 3
A customer has four or more nodes in a cluster. More than four target ports are being used by the SVMs in any node. The customer wants to limit the number of paths that can be used to access LUNs on the nodes, so that the paths do not exceed the recommended maximum of eight. In this scenario, which three actions will accomplish this task? (Choose three.)
A. Use ALUA protocol.
B. Use multipathing software.
C. Use port sets for iSCSI.
D. Use Selective LUN Mapping
E. Use FC switch zoning.
Answer: C, D, E
Question: 4
A customer configured CIFS in an ONTAP 9.5 SVM. The customer wants to verify if the “CIFS Server” is accessible from each node of the cluster. In this scenario, which command will accomplish this task?
A. Vserver cifs session
B. Vserver cifs connection show
C. Vserver cifs check
D. Vserver cifs domain discovered-servers
Answer: C
FOR MORE INFORMATION
VISIT NOW :
0 comments:
Post a Comment
Note: Only a member of this blog may post a comment.